Nowadays, lithium batteries are widely used in electronic products, rechargeable batteries, electric vehicles, balance vehicles, aircraft models, ship models, electronic tools, and so on. Due to the diversity of battery shape and volume and the limitation of power supply mode, the traditional welding machine lacks flexibility. SQ-SW1 is battery powered, OLED display can show high and low voltage warnings. Using the new spot welding technology, and intelligently switching automatic or manual working mode to meet different needs. It is a flexible and efficient welding tool.

Safety Tips

1. The two electrodes and solder pins should not be touched together to avoid short circuits.

2. Pay attention to the correct wiring. Refer to the manual for the specific wiring method.

3. When using for the first time, set the welding pulse duration to 2ms and check the welding result. According to the actual welding situation, set the appropriate welding pulse duration step by step to obtain good welding.

4. If you use higher current or non-factory parts, you need to take the risk yourself.

Specification:

Input Voltage: 10-14V

Welding Thickness: 0.1-0.3mm

Trigger Delay: 0.5-3s

Screen Flip: 180°

Pulse Time: 1-100ms(default),1-500ms（setting）

Short Pulse: 0-100%

Work Model: Automatic/Manual

Voltage Warning: Low Voltage/High Voltage

Power Supply Interface: XT90

Recommended Battery: Lithium battery (3S 5000-8000mAh 60-75C) ,Car battery (12V 400-800CCA)

Note: For batteries with a discharge coefficient less than 60C, only nickel stripe with a thickness of 0.1 can be spot welded; If the discharge coefficient is greater than 75C, it may burn the internal motherboard of the host.

Package included:

1× Host

1× welding pen

1× nickel stripe

1× foot pedal

2× Solder pin

2× battery holder