FEATURES

72-channel M8 engine GPS L1C/A, SBAS L1C/A, QZSS L1C/A, QZSS L1 SAIF, GLONASS L1OF, Galileo E1B/C

On-board Ultra low noise 3.3V voltage regulator and RF filter for noise blocking

Features an additional front-end LNA for optimized performance and a front-end SAW filter for increased jamming immunity

Build-in embedded GNSS patch antenna, low power consumption

The 15 x 15 mm patch antenna provides the best compromise between the performance of a Right Hand Circular Polarized (RHCP) antenna and a small size to be integrated in any design.

Magnetic sensor QMC5883L integrated

Max navigation update rate

  • Single GNSS up to 18 Hz
  • 2 Concurrent GNSS(GPS & GLONASS) up to 10 Hz

Horizontal position accuracy(GPS & GLONASS) 2.5 m CEP

Velocity accuracy 0.05m/s

Cold start 26 s

Aided cold starts: 2 s

Hot start 1 s

Sensitivity

  • Tracking & Navigation: –165 dBm
  • Reacquisition: –158 dBm
  • Cold start: –146 dBm
  • Hot start: –155 dBm

Input voltage range: 4~6V

Power consumption: 40mA

Uart (Tx,Rx) interface for GPS SAM-M8Q

I2C (DA,CL) interface for Compass QMC5883L

Battery for HOT module start

Power LED(Red) & Time pulse LED(Blue)

Dimensions: L20 x W20 x H10 mm

Weight: 7 gram

Supported by INAV/Betaflight/Ardupilot, ect.


Tips

  • GPS, GLONASS, SBAS, QZSS are enabled by default
  • u-blox M8Q series has no external flash memory
  • Blue PPS LED blinking(1Hz) means 3D fixed
  • update rate 1Hz & baudrate 9600 default
  • Baud 9600~115200 supported by INAV/BF/Ardupilot
  • update rate 5Hz with INAV UBLOX Protocol
  • update rate 10Hz with INAV UBLOX7 Protocol
  • Compass Alignment(Arrow forward and flat mounting):
  • INAV/BetaFLight: CW 270° Flip when flight controller arrow is facing forward also
  • Ardupilot/Mission Planner: Rotation None
  • BF doesn’t support GPS position hold and RTH,  GPS Rescue mode is supported by BF3.5 or last.
  • No need compass for Fixed wings with INAV firmware
  • The scratches on ceramic antenna are the result of tuning the antenna by ublox.
  • Make sure to have compass/magnetometer 10cm away from power lines/ESC/motors/iron based material


Package Included:

1x M8Q-5883 module

1x SH1.0-6P 20cm silicon wire

Transparent PVC Heat-shrink tube

Uzrakstīt atsauksmi

Please login or register to review

Matek GPS & Compass M8Q-5883

  • Ražotājs: Matek Systems
  • Produkta kods: M8Q-5883
  • Pieejamība: Izpārdots
  • 38.90€

  • bez PVN: 32.15€