FEATURES

• F405 has 1MB flash which can run with ArduPilot.  even with INAV firmware, some features will be removed on F722 due to limited flash.
• The advantage of F722 is all UARTs have builtin inversion which is not needed when CRSF protocol is widely used on new receivers.
• Redesigned target MATEKF405TE support 8x bi-directional DSHOT.
• Support DJI air unit PnP, and a 10V BEC for DJI OSD or analog VTX
• Compared with F722-miniSE 8motors or 6motor+2servos, F405-miniTE support 8motors+3servos in INAV/BF multirotor mixer
• InvenSense GEN3 IMU ICM426XX

Specification:

MCU: STM32F405RGT6

IMU: ICM42605 or ICM42688-P

OSD: AT7456E, DJI OSD

Baro: Goertek SPL06-001 (I2C)

Blackbox: 16M-byte Flash memory

6x UARTs,  1x Softserial_Tx option

12x PWM outputs (8x Dshot)

1x I2C

4x ADC (VBAT, Current, RSSI, Airspeed)

2x PINIO

1x SH1.0_8pin connector (Vbat/G/Curr/R3/S1/S2/S3/S4)

1x SH1.0_6pin connector for DJI FPV Air Unit

3x LEDs for FC STATUS (Blue, Green) and 3.3V indicator(Red)

Dual BEC, 5V 1.7A & 10V 1.4A

10V output ON/OFF switchable

Convertible 20mm to 30.5mm mounting

Input: 6~30V (2~S LiPo)

BEC: 5V 1.7A,  Max.2A

BEC: 10V 1.4A  for VTX or DJI Air Unit

For stable 10V output, input voltage should > 11V,  when input voltage =<11V, output = 90% input voltage.

Battery Voltage Sensor: 1K:20K (INAV scale 2100, BF scale 210)

No Current Sensor built-in, supports external current sensor of PDB/4in1

ArduPilot: MatekF405-TE

INAV: MATEKF405TE

BetaFlight: MATEKF405TE

Mounting:

• 20 x 20mm/Φ3mm with Silicon Grommets
• 20 x 20mm/Φ2mm with Silicon & Brass Grommets
• 30.5 x 30.5mm/Φ3mm with Conversion Plate and Silicon Grommets

Dimensions:  28 x 28 mm

Weight: 5g

Package Included:

1x FC F405-miniTE

1x 20mm to 30.5mm conversion plate(blue PCB)

6x Silicon grommets M4 to M3

6x Brass grommets M3 to M2

1x SH1.0_8pin cable 5cm (including 2x 8pin connectors) for 4in1 ESC

1x SH1.0_6pin to GH1.25_8pin cable 8cm for DJI Air Unit

Downloads and setup information for BF and iNav