Soldering pads

• Vbat: for voltage sense, support 0~69V IN
• Volt: = 1/21 Vbat, 0~3.3V out
• Curr: Current signal, 0~3.3V out
• 5V: power supply for HCS-150A board, support 4~13V IN, 17mA
• G: GND
• TX/RX: for firmware update and configure (to be supported)

Specification:

Hall effect current sensor

No voltage drop and heat on current sensor components

Offset and Sensitivity are calibrated in factory

Continuous current rating: 0~150A DC

Sensitivity: 20mV/A,  INAV/BF scale = 200,  ArduPilot BATT_AMP_PERVLT = 50

VBAT voltage sense: 0~69V,  INAV scale = 2100,  BF scale = 210, ArduPilot BATT_VOLT_MULT = 21.0

Power Consumption: 17mA

Voltage offset error at zero current : +-10mV

Curr output voltage error: 5%

Operating Temperatures: -30~80 °C

23 * 20* 23mm, 7g

Package Included:

1x Hall sensor