The Happymodel Mobula6 Race HD BNF is the first 65mm HD brushless tiny whoop that weighs less than 19.4g. With tiny whoops, every gram makes a large difference in flight performance. To achieve such a low weight, HDZero has developed the world’s first 5-in-1 AIO that contains a HDZero VTX, FC, ESC, ELRS RX, and 5V1A BEC. Using a single thick PCB rather than a stack of 2 improves durability and simplicity – get ready for a new era of no-compromise tiny whooping in clear digital video!

To keep weight and cost to a minimum, the Race HD BNF features the light weight HDZero Eco camera. The camera outputs HD composite video (720p) via a single wire instead of a MIPI cable, reducing footprint, cost, and increasing durability. The digital video signal has stable color reproduction and 720p progressive scan video with the stable near-zero latency HDZero is known for.

In order to achieve the goal of extreme weight reduction, HAPPYMODEL used original Japanese RENY screws at all costs, and also designed a lighter 5.8G VTX antenna. All these improvements are to make this HD BNF weigh less than 20 grams. We hope you like it.

Specification:

Weight: 19.3g

Recommended Battery: 1S 300mAh

Propeller Size: 31mm

Flight time: around 2.5~3 minutes

AIO Flight controller

MCU: STM32F411 (100MHz, 512K Flash)

Gyro: BMI270

On board voltage and amperage meters

Built-in 5A(each) BLHeli_S 4-in-1 ESC

Built-in 5.8G HDZero VTX

Built-in SPI ExpressLRS 2.4GHz receiver

Built-in 5V 1A BEC

Board size:28.5×28.5mm with a 25.5×25.5 mounting hole size

Firmware target: CRAZYBEEF4SX1280

HDZero Eco Camera

Sensor size: 1/3 inch

Resolution: 720p60 4:3

FOV: D:150° H:120° V:98°

Motors

Kv:28000

Stator diameter: 7mm

Stator length:2mm

Shaft diameter: Φ1mm

Weight:1.5g

Package included:

1x Happymodel Mobula6 Race HD BNF

1x Spare canopy

1x Spare propeller(set)

1x Screw driver

1x propeller disassemble tool