Covid-19 informācija: Pasūtījumi tiek izsūtīti katru dienu

The Omnibus Fireworks flight controller uses the ICM20608 over SPI for the best possible flight performance. With onboard damping box, the ICM20608 runs perfectly under 32k Gyro loop. If you haven't already seen it, you should check out Josh's awesome video on different IMUs. Also onboard are a barometer and AB7456 OSD chip for the BetaFlight integrated OSD.


Omnibus Fireworks supports 3-6s LIPO direct input, build in hall Current Sensor and Power Filter too.


The on Board PDB is tweaked by using 12-Layer PCB design. There is only 0.2-0.5 mohm internal resistance from input to each output pads


Modifications on v2:

Tantalum Capacitors can be added to the board (not included)

Solder pads added for SmartAudio and Camera Control (next to Video pads)

The orientation of IMU FPC optimized

Gyro ribbon cable redesigned to fit without extending outside the board

Added an 8v BEC and LC Filter for the camera and VTX power

This board now has 5 UART ports


Specification:

STM32 F405 MCU, Runs Betaflight firmware(supported from v3.2)

ICM20608 Over SPI Bus in damping box. (optional MPU6000)

30.5x30.5mm Mounting holes

Supports Lipo direct plugin (3-6S)

Supports 5V 1A BEC output (Buck)

Supports 8V 1A BEC with LC filter output for the camera and VTX(Buck)

STM32 controls OSD chip over SPI in DMA mode (Betaflight OSD)

Built-in hall Current Sensor

Built-in Professional Level PDB

More caps to reduce power noise.


Package Included:

1x Airbot Fireworks FC

Uzrakstīt atsauksmi

Please login or register to review

Airbot Omnibus F4 Fireworks V2.1 Flight Controller

  • Ražotājs: Airbot
  • Produkta kods: Fireworks v2.1
  • Pieejamība: Noliktavā
  • 37.50€

  • bez PVN: 30.99€

Related Products

Cable JST 8 pin 30mm For 4in1 ESC

Cable JST 8 pin 30mm For 4in1 ESC

This is a silicone cable harness designed to connect your airbot flight controller directly to an ai..

1.15€ bez PVN: 0.95€

Cable JST 8 pin 70mm For 4in1 ESC

Cable JST 8 pin 70mm For 4in1 ESC

This is a silicone cable harness designed to connect your airbot flight controller directly to an ai..

1.15€ bez PVN: 0.95€

Cable set SH1.0

Cable set SH1.0

Pre-crimped silicone wires and spare JST SH1.0 connectorsPackage Included:12 x 55MM 12x 105MM 12x 15..

4.90€ bez PVN: 4.05€

Tags: aio