FEATURES

• Use mainstream STM32F405 chip
• Equipped with the latest 42688-P gyroscope
• 16M black box storage
• Integrated LC filter
• Upgrade type-C USB interface
• Directly plugged into the DJI Air Unit
• With TAKER H100_8S_BLS 100A 4IN1 ESC, Dual MOS, high current, silky flight
• Supports 8S Lipo battery
• Simple and reasonable installation method, the shock absorber can make the gyroscope work very stably
• 12V@3A + 5V@3A dual independent BEC

Specification:

GEP-F405-8S Flight Controller

MCU：STM32F405

IMU：ICM42688-P(SPI)

Air Unit Connection：Direct plugging into DJI Air Unit

Black Box：16M onboard

Barometer: support

Motor outputs：M1-M8

USB Interface：Type-C

OSD：BetaFlight OSD w/ AT7456E chip

BEC：5V@3A,12V@3A dual BEC

Firmware Target：GEPRCF405_BT_HD

Size：37x37mm

Mounting: 30.5×30.5mm，φ4mm hole becomes φ3mm after using a silicone shock-absorbing circle

Input Voltage：3-8S LiPo

UART：6 UARTs

Power Filter：Integrated LC filter

Weight：8.3g

TAKER H100_8S_BLS 100A 4IN1 ESC

Input Voltage: 3-8S Lipo

Ammeter: Support

Calibration value：200

Continue Current：100A

Burst Current：105A（5 second）

Support Protocol: Dshot 150/300/600

Size：56.3*61.1mm，hole30.5×30.5mm，φ4mm hole becomes φ3mm after using the silicone shock-absorbing ring.

Weight: 28.8g

Target: B_X_3

Package Included:

1x FC board

1x ESC board

1x Capacitor

1x O3 3-in-1 connection cable

2x FC adapter cable

1x sh1.0 4pin silicone cable

1x Camera connection cable

1x VTX connection cable

1x XT90 power cable

4x M3*30 screws

4x M3*25 screws

8x Nylon nuts

12x Silicone anti-shake pads