The PDB-XT60 has been engineered to provide the highest possible performance and reliability in a 36x50mm & 4 layers PCB. It distributes power from a LiPo pack to 6 ESCs, as well as providing synchronized & regulated DC 5V outputs & linear regulated DC 12V for powering Cameras, Servos, RC receiver, Flight Controllers, Video Transmitters, LEDs, etc.
It offers a XT60 socket to connect the LiPo pack conveniently.
- 2oz copper & 4-layers PCB.
- ESC & Battery solder tabs in pairs.
- Solder Bridges of various voltage for Camera & VTX.
- DC/DC synchronous buck regulator, Efficiency is up to 95%.
- TVS(Transient Voltage Suppressor) protection for DC/DC chip.
- 5V & 12V Output LED indicators & Short circuit tolerant.
Dimensions: 36 x 50 x 4 mm (without XT60)
Weight: 7.5g(w/o XT60), 11g(w/ XT60)
Mounting: 30.5 x 30.5mm, Φ3mm
Continuous current: 25Ax4 or 15Ax6
Peak current (10 seconds/minute): 30Ax4 or 20Ax6
BEC 5V output:
Designed for RC Receivers, Flight controllers, OSD, and Servos.
DC/DC synchronous buck regulator.
Voltage: 5.0 +/- 0.1VDC
Continuous current: 2 Amps (Max.2.5A 10s/minute)
Output Ripple: 40mV (VIn=16V, VOut=5V@2A load)
Short-circuit tolerant (5 seconds/minute)
BEC 12V output:
Designed for Video TX or FPV camera with linear regulator.
The battery should be 4S LiPo (13~18V DC)
Voltage: 12.0 +/- 0.3VDC
Continuous current: 500mA (Max.0.8A 5s/minute)
Short-circuit tolerant (2 seconds/minute)
BEC 12V @ 3S LiPo
Output voltage= 3S LiPo voltage -1V
Matek Power Distribution Board XT60 With BEC 5V And 12V
- Ražotājs: Matek Systems
- Produkta kods: PDB-XT60
- Pieejamība: Izpārdots
- bez PVN: 5.37€